HP Jetdirect J7974E Administrator's Manual page 169

Table C-1 HP Jetdirect Control Panel Menu (continued)
Menu Item
ENWW
Submenu Options Additional Options
MANUAL
SETTINGS
DEFAULT IP
PRIMARY DNS
SECONDARY DNS
IPV6 SETTINGS ENABLE
ADDRESS
DHCPV6 POLICY
Description of settings
(Available only if CONFIG METHOD is set to MANUAL)
Configure parameters directly from the printer control
panel:
●
IP ADDRESS n.n.n.n: The unique IP address of the
printer, where n is a value from 0 to 255.
●
SUBNET MASK m.m.m.m: The subnet mask for the
printer, where m is a value from 0 to 255.
● SYSLOG SERVER n.n.n.n: The IP address of the
syslog server used to receive and log syslog
messages.
●
DEFAULT GATEWAY n.n.n.n: The IP address of
the gateway or router used for communications with
other networks.
●
IDLE TIMEOUT: The time period, in seconds, after
which an idle TCP print data connection is closed
(default is 270 seconds, 0 disables the timeout).
Specify the IP address to default to when the print server
is unable to obtain an IP address from the network during
a forced TCP/IP reconfiguration (for example, when
manually configured to use BootP or DHCP).
●
AUTO IP: A link-local IP address 169.254.x.x will be
set.
●
LEGACY: The address 192.0.0.192 will be set,
consistent with older Jetdirect products.
Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Specify the IP address (n.n.n.n) of a Secondary Domain
Name System (DNS) Server.
Use this item to enable or disable IPv6 operation on the
print server.
ON: IPv6 will be enabled.
OFF: IPv6 will be disabled.
Use this item to manually configure an IPv6 address.
MANUAL SETTINGS: Use the MANUAL SETTINGS
menu (see the additional options under IPV6
SETTINGS) to enable and manually configure a TCP/
IPv6 address.
LINK-LOCAL: Use this item to display the IPv6 link-local
address configured on the print server.
DHCPV6: If available, use this item to display stateful
IPv6 addresses controlled by a DHCPv6 server.
ROUTER SPECIFIED: If available, use this item to
display stateless addresses associated with a router.
ROUTER SPECIFIED: The stateful auto-configuration
method to be used by the print server is determined by
Parameter Descriptions 159