Ipv4 Section - HP Jetdirect J7974E Administrator's Manual

Table 8-5 TCP/IP Configuration Information (continued)
Message
IDLE TIMEOUT:

IPv4 Section

The following table includes items displayed under the IPv4 section of the configuration page.
Table 8-6 IPv4 Section
Message
STATUS:
IP ADDRESS:
SUBNET MASK:
DEFAULT GATEWAY:
CONFIG BY:
124 Chapter 8 HP Jetdirect Configuration Pages
Description
Not Specified: Indicates that a WINS server's IP address has not been configured on
the print server.
The timeout value expressed in seconds after which the print server closes an idle TCP
print data connection. Acceptable values are integers between 0 and 3600. A value of
zero turns off the timeout mechanism. The default value is 270 seconds.
Description
Current TCP/IPv4 status.
READY: Indicates the HP Jetdirect print server is awaiting data over TCP/IP.
DISABLED: Indicates that TCP/IP was manually disabled.
INITIALIZING: Indicates that the print server is searching for the BOOTP server, or
trying to get the configuration file through TFTP. An additional status message may also
be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see Table 8-12 Error
The Internet Protocol version 4 (IPv4) address assigned to the HP Jetdirect print server.
This is a required entry for operation of the print server on a TCP/IP network. During
initialization, a temporary value 0.0.0.0 is displayed. After two minutes, a default IP
address 169.254/16 or 192.0.0.192 is assigned.
Not Specified: Indicates that an IP address is not assigned or the value is zero.
The IPv4 subnet mask configured on the HP Jetdirect print server. During initialization,
a temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the
print server may automatically assign a usable default value.
Not Specified: Indicates that a subnet mask is not configured.
The IPv4 address of the gateway used when sending packets off the local network. Only
one default gateway may be configured. During initialization, a temporary value 0.0.0.0
is displayed. If not provided, the IP address of the Jetdirect print server is used.
Not Specified: Indicates that a default gateway is not configured.
Identifies how the HP Jetdirect print server obtained its IPv4 configuration:
BOOTP: Automatic configuration through a BOOTP server.
BOOTP/TFTP: Automaticautomatic configuration through a BOOTP server and TFTP
configuration file.
DHCP: Automatic configuration through a DHCP server
DHCP/TFTP: Automatic configuration through a DHCP server and TFTP configuration
file.
RARP: Automatic configuration through the Reverse Address Resolution Protocol.
Messages.
ENWW