Ipv6 Section - HP Jetdirect J7974E Administrator's Manual

Table 8-6 IPv4 Section (continued)
Message
BOOTP SERVER:
or
DHCP SERVER:
or
RARP SERVER:
BOOTP/DHCP SERVER:
TFTP SERVER:
WEB JETADMIN URL:
MDNS (BONJOUR) SERVICE
NAME

IPv6 Section

The following table includes items displayed under the IPv6 section of the configuration page.
Table 8-7 IPv6 Section
Message
STATUS:
ENWW
Description
USER SPECIFIED: Manual configuration through Telnet, the printer's control panel, HP
Web Jetadmin, embedded Web server, or other method.
DEFAULT IP: The default IP address was assigned. This address may not be a valid
address for your network.
AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a link-
local network, this address should be valid.
NOT CONFIGURED: The print server was not configured with IP parameters. Verify
that TCP/IP is enabled, or check for error status.
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the
IP address of the system that responds to the HP Jetdirect print server's request for
automatic TCP/IP configuration over the network.
Not Specified: Indicates that the configuration server's IP address could not be
determined or was set to zero in the response packet.
Displayed during initialization while the HP Jetdirect print server attempts to obtain its
TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed
is 0.0.0.0.
The IP address of the system where the TFTP configuration file is located. During
initialization, the temporary address 0.0.0.0 is displayed.
Not Specified: Indicates that a TFTP server has not been not been set.
If the HP Jetdirect print server is found on the network by HP Web Jetadmin, the URL
of the host system used for HP Web Jetadmin services is displayed. The URL is limited
to two lines and may be truncated.
Not Specified: Indicates that the URL of the Web Jetadmin host system could not be
identified or is not configured.
Specifies a name (alphanumeric string) assigned to this device or service. This name
is persistent and is used to resolve a particular device or service if socket information
(such as the IP address) changes from session to session. Apple Bonjour will display
this service. The default service name is the printer model and the LAN Hardware (MAC)
address.
Description
Current TCP/IPv6 status.
READY: Indicates the HP Jetdirect print server is awaiting data over TCP/IP.
DISABLED: Indicates that TCP/IP was manually disabled.
INITIALIZING: Indicates that the print server is searching for the BOOTP server, or
trying to get the configuration file through TFTP. An additional status message may also
be displayed.
HP Jetdirect Configuration Page 125