HP Jetdirect J7974E Administrator's Manual page 141

Table 8-12 Error Messages (continued)
Error Code and Message
1A PRINTER NUMBER NOT
DEFINED
1B PRINTER NUMBER IN USE
1C PRINT SERVER NOT DEFINED
1D UNABLE TO CONNECT TO
SERVER
1E FAIL RESERVING PRINTER
NUM
1F ERR NEGOTIATING BUFFER
SIZE
20 UNABLE TO LOGIN
21 UNABLE TO SET PASSWORD
22 UNABLE TO CONNECT TO
SERVER
23 UNABLE TO ATTACH TO
QUEUE
ENWW
Description
NOTE When multiple file servers are configured, the error is only displayed
on the configuration page if none of the file servers were successfully
connected.
A NetWare printer number for this printer has not been configured. Assign a valid printer
number to the HP Jetdirect print server. Use a NetWare utility (such as PCONSOLE),
the Jetdirect embedded Web server, or other tool to assign a printer number.
The NetWare printer number assigned to the printer is already in use by another printer.
Assign an unused printer number. This may also occur when a printer is powered off/
on, in which case the error goes away after the print server times out and detects the
lost connection.
The file server does not have a print server object that corresponds to the specified
NetWare node name. Use printer installation software, a NetWare utility (such as
PCONSOLE), or other tool to create the print server object.
When the HP Jetdirect print server is configured for multiple file servers, the error is only
displayed on the configuration page if none of the file servers made the connection.
Remote Printer mode error: The HP Jetdirect print server was unable to establish an
SPX connection with the NetWare print server. Make sure that the NetWare print server
is running and that all cables and routers are functioning correctly.
The SPX connection to the print server was lost when the HP Jetdirect print server
attempted to reserve the printer number. This indicates a possible network problem, or
a problem with the print server. Make sure all cables and routers are functioning
correctly. Try restarting the print server.
A failure was detected when selecting the buffer size to be used when reading print data
from the file server. This may indicate a network problem.
When the HP Jetdirect print server is configured for multiple file servers, the error is only
displayed on the configuration page if none of the file servers was successfully
connected.
A failure was detected when the HP Jetdirect print server tried to log onto the file server.
This could be caused by the print server object not existing on the file server, or by a
security check that prevents the print server from logging in.
Make sure the file server name and print server object name are correct. Use
PCONSOLE to erase the password for the print server object. Create a new print server
object.
When the HP Jetdirect print server is configured for multiple file servers, the error is only
displayed on the configuration page if none of the file servers made the connection.
A failure was detected when the HP Jetdirect print server tried to set the password for
the print server object. (Whenever the HP Jetdirect print server is able to log in without
a password, it sets the password automatically.) This indicates a networking or security
problem. Create a new print server object.
When multiple file servers are configured, the error is only displayed on the configuration
page if none of the file servers were successfully connected.
Queue Server mode error: The HP Jetdirect print server could not establish an NCP
connection to the file server. Make sure that the correct file servers are connected.
When multiple file servers are configured, the error is only displayed on the configuration
page if none of the file servers were successfully connected.
A failure was detected when the HP Jetdirect print server tried to attach to one of the
queues assigned to the print server object. This may be because no servers are allowed
to attach to this queue. There may also be a networking or security problem. Use
HP Jetdirect Configuration Page 131