Advertisement
0$,17(1$1&(
)LOWHU 5HSODFHPHQW
3URFHGXUH
67(3
67(3
8VHU·V 0DQXDO
0LUDJH
It is a good idea to replace the 2 side filters whenever the lamp module is replaced (or
more frequently if operating the projector in a dusty environment). These filters lie
along the right side panel of the projector, running from the front edge to about 9
inches from the rear.
7XUQ RII WKH SURMHFWRU FRRO DQG XQSOXJ
Before removing or installing a filter, turn off the projector and allow to cool for five
minutes before unplugging.
5HPRYH WKH ILOWHU JULOOH
Remove the 6 screws securing the filter grille to the projector (Figure 4.9).
Pull out the old filters and replace with the new, wire side in. Align the first filter to
the front edge of the projector and follow with the second so that the last 9 inches
(approx.) are not covered by filter. See Figure 4.10. Replace the grille and secure
with the 6 screws.
:$51,1*
8QSOXJ WKH SURMHFWRU
)LJXUH 5HPRYH ILOWHU JULOOH
)LJXUH ,QVWDOO ORQJ DQG VKRUW ILOWHUV
:$51,1*
8VH RQO\ &KULVWLH ILOWHUV 1HYHU RSHUDWH
WKH SURMHFWRU ZLWKRXW WKH ILOWHUV LQVWDOOHG
Advertisement
