Advertisement
&RQYHUWLQJ D .H\SDG
6+257&87 0(7+2'
You can also issue software protocol settings through the keypad. These software
commands will be lost when the keypad is either unplugged or when a battery is
removed — the keypad will revert back to the hard-wired jumper settings (see above)
until you enter the software commands again.
NOTE: If you change any keypad to a new protocol and the projector stops
responding, the projector may be set to a conflicting protocol. Use the projector's
built-in keypad to access the Communications menu. Under "Front IR" or "Back
IR" or "Wired Keypad", select the protocol that matches the new protocol of the
keypad at hand. The projector should now respond properly.
If desired, you can convert an IR remote keypad into a wired remote keypad and vice
versa.
72 &+$1*( )520 ,1)5$5(' 72 :,5('
N
Remove battery compartment cover from back of keypad.
N
Remove batteries.
N
Wait 1-2 minutes.
N
Plug the keypad cable (available separately) into the empty battery
compartment. Make sure that the battery cover is notched smoothly to
accommodate the cable without pinching it.
N
Set keypad protocol as desired, using "wired" jumper settings.
N
Replace battery compartment cover.
N
Plug into the 3-pin XLR port at the front panel of the projector.
72 &+$1*( )520 :,5(' 72 ,1)5$5('
N
Unplug the keypad from the projector.
N
Open the keypad back and unplug the keypad cable.
N
Wait 1-2 minutes.
N
Install batteries (see Section 4).
N
Set keypad protocol as desired, using "IR" jumper settings.
N
Replace battery compartment cover.
3RVLWLRQ
,QSXW &RORU
3L[HO
Press
3RVLWLRQ
,QSXW &RORU
3L[HO
Press
,167$//$7,21 6(783
$
= Protocol "
"
%
= Protocol "
"
8VHU·V 0DQXDO
0LUDJH
Advertisement
