Advertisement
',PDJHV
'HVFULSWLRQ
+RZ WR $FWLYDWH '
03:
projector model name and serial number. In addition, the Status menu identifies the
current channel, switcher, slot and frequencies.
Use
,
,
A single projector can display 3D images as described below. In order to be
displayed and interpreted correctly in a typical 3D active stereo viewing environment
such images usually require a specialized 3D source as well as the additional
hardware and software described here.
In simple terms, images generated from a 3D-video source consist of a series of
images (frames or fields) that alternate quickly between two slightly different
viewpoints corresponding to the separation of our left and right eyes. When these
frames are displayed with enough speed and viewed with special glasses
synchronized with the left/right frames, the resulting "single" perceived image
appears with much the same depth and perspective we sense in the real world.
86,1* ´0,1,080 '(/$<µ 5(&200(1'('
and hardware/software setups described below, select the Processing Mode option
"Minimum Delay" located in the Advanced Image Settings menu—the projector does
not automatically detect and process a 3D signal using this mode. Note that the
"Minimum Delay" setting is applied only to the current source and must be selected
for each 3D source you wish to process with this mode. For complete processing
information, see 3.7, Adjusting System Parameters and Advanced Controls.
86,1* ´*5$3+,&6+'79µ 5$5(
mode for most 3D displays, you can sometimes process using "Graphics/HDTV" if
you have the following sources:
Y
Signals less than 1024 x 768 resolution—processed up to 120 Hz frame rate
Y
1024 x 768 up to 100 Hz frame rate
or
to see additional Status information.
)LJXUH 6WDWXV 0HQX 6$03/(
Although "Minimum Delay" is the recommended
Once you have the necessary source
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
Advertisement
