Advertisement
23(5$7,21
8VHU·V 0DQXDO
0LUDJH
,QSXW
,QSXW
,QSXW
Press
to select the source connected to
interface). This is the same as entering
,QSXW
,QSXW
Press
,QSXW
to select the source connected to
video). This is the same as entering
,QSXW
,QSXW
Press
,QSXW
to select the source connected to
is the same as entering
,QSXW
,QSXW
,QSXW
Press
switcher connected serially to the projector's switcher port. The first digit represents
the number you have assigned to your switcher (usually 1-9, or "0" for one of the
four inputs on the projector). The second digit represents the switcher's slot number
(1-9). For example:
,QSXW
NOTES: 1) Although you don't need to use the input key unless a switcher is
connected to the projector, you can also use
the projector itself: use
switcher), then
in combination with higher numbers is an invalid entry. 2) See 3.5, Using
Channels and Inputs for a detailed explanation of inputs.
NOTE:
,QSXW
key behavior during a presentation depends on whether or not the
Display Channel List option is selected in the Preferences menu. You can choose to
have on-screen feedback when you press
source location "blind", i.e., without on-screen feedback. See Preferences later in
this section.
&KDQ
&KDQQHO
&KDQ
Press
to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel.
NOTE:
&KDQ
key behavior during a presentation depends on whether or not the
Display Channel List option is selected in the Preferences menu. You can choose to
use a scrollable list of channels when you press
desired channel number "blind", i.e., without on-screen feedback. See Preferences
later in this section.
6WE\
6WDQGE\
6WE\
Press
and hold for approximately 1 second to blank all display while keeping the
projector in a warmed-up and ready state. Or quickly press and release
follow immediately by
(useful if you are unsure of the present status). Note that the lamp and electronics
remain ON in standby mode, even though the image turns to black and most
,QSXW
,QSXW
,QSXW
.
when you want to display from a specific source location, such as a
= display data from switcher 1, slot 2.
as the first digit (representing the projector as the
,
,
, or
as the second digit (the desired input slot number).
(QWHU
), the display will automatically change and update
21
or
2))
if you want to guarantee the correct toggle
on the projector (an optional
,1387
.
on the projector (composite
,1387
.
on the projector (S-Video). This
,1387
,QSXW
to access the four input "slots" on
,QSXW
, or you may prefer to enter the desired
&KDQ
, or you may prefer to enter the
6WE\
and
Advertisement
