Advertisement
:LUHG 5HPRWH
³237,21$/³
*XLGH WR .H\SDGV
.H\SDG &RPPDQGV
3RZHU
,QSXW
The wired remote keypad connects to the 3-pin XLR jack via a 50 ft. cable. It is
recommended when:
N
the rear keypad is inaccessible
N
the lighting conditions are unsuitable for proper IR transmission
N
you want to use a separate keypad for each projector in a group
NOTES: 1) For extra long distances and/or harsh environments, you may prefer to
use an optional remote Two-Way Controller to control the projector. For operating
details, please see the Two-Way Controller User's Manual included with this
accessory. 2) Old VistaGRAPHX "Roadie style" keypads can be used with this
projector, but most
Keep in mind the following guidelines:
Press keys one-at-a-time; there are no simultaneous key presses required.
For any key having an "*" (
second in order to toggle the function with a single key press. For other keys (or
to use a "*" key in conjunction with
a mouse click is sufficient.
Press the "lightbulb key" to temporarily illuminate the backlight for the keys
without sending any other command.
,
,
21
other keys, release and press again to repeat an action. In a serial network, pause
briefly between adjustments to ensure that more distant projectors can "keep up"
with the commands.
If you press a key while the projector is busy with another action, such as during
a power-up, the key press may not take effect.
When you turn on the projector it begins operating at presentation level, such as an
image from the most recently used source signal. The projector temporarily leaves
presentation level whenever you use the keypad to work with control settings, display
menus, or on-line help. For example, pressing
menu — presentation level is no longer active, although the image still appears in the
background. Press
to presentation level.
Specific keypad commands are explained below:
3RZHU 212))
Press and hold for approximately 1 second to turn the projector on or off with a
single key press (note the AC I/O switch must be on). Or press
21
immediately by
you are unsure of the present status).
NOTES: 1) Whenever the projector is turned off, the lamp cooling fans remain on for
about five minutes to cool the lamp. 2) It is a good idea to avoid turning a projector
back on until it has been off for a few minutes. Hot re-strikes of the lamp may reduce
lamp life. 3) Do not turn off with the AC I/O switch.
,QSXW
,QSXW
Press
to select the source connected to
This is the same as entering
)XQF
key codes listed on the back are different and do not apply.
3RZHU
, for example), hold the key for approximately 1
, and
2))
repeat their "arrow" actions when held down. For
0HQX
again (or
([LW
) to return or leave the menu system and return
2))
or
if you want to guarantee the correct toggle (useful if
,QSXW
.
21
or
2))
), a momentary press similar to
0HQX
after startup displays the main
3RZHU
on the projector (data input).
,1387
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
followed
Advertisement
