Advertisement
Section 2, Installation and Setup for an illustrated explanation of offset ranges for all
lenses. Ranges are also listed on page 5-1. Offsets cannot be adjusted manually.
5(027( &21752/ 6+877(5
the image to off. Although the lamp remains "on", its output is reduced to prevent
heat build-up. The shutter is controlled via
&20326,7(69,'(2 ,1387
devices such as VCRs. This input is optional on this projector.
Accepts RGB and sync signals from devices such as computers, as well
5*% ,1387
as composite video, S-Video or YPbPr component signals.
56 6(5,$/ ,17(5)$&( :,7+ /223 7+528*+
be remotely controlled by a computer or controller, and provides a communications
connection for Marquee Signal Switchers.
56 6(5,$/ ,17(5)$&( :,7+ /223 7+528*+
be remotely controlled by an RS-422 compatible computer or controller (such as the
Two-Way Controller accessory). RS-422 communications can travel greater distances
than can RS-232 communications, and require RS-422 compatible equipment.
$& /,1( &25' ,1387
to 60 Hz (15 amps @ 200 VAC). Always use the projector's integral line cord, and
never alter this cord or plug. See complete power specifications in Section 5.
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ LV QRW ZLWKLQ
WKH VSHFLILHG YROWDJH DQG SRZHU UDQJH
67$78632:(5 /('6
corner of the front connector panel indicate projector "Status" (top) and "Power"
(bottom). During normal operation, the "Power" light is steady green and the "Status"
light flashes green each time a key is pressed or when the projector receives a serial
command. Use the following as a guide:
Closing the shutter blocks the lens internally and turns
6KXWWHU
Accepts a composite video and S-Video signal from
The projector requires AC power of 200 to 240 VAC, 50
:$51,1*
Two LEDs (light emitting diodes) located in the lower right
23(5$7,21
on the keypad.
Allows one or more projectors to
Allows one or more projectors to
8VHU·V 0DQXDO
0LUDJH
Advertisement
