Advertisement
means that connected projector is listening; if there is no checkmark, you are
communicating with a different projector.
To use a specific projector, enter the 3-digit number assigned to the projector you
want to use. Press
other than the one you are currently using, the checkmark will be deleted.
To broadcast to multiple projectors, press
projector number. Keypad commands will then affect all projectors present.
NOTES: 1) The "Broadcast Keys" option in the Communications menu must be
selected for only one (any) projector in a serial network. The keypad in use must be
OFF (disabled) for the remaining projectors. See 2.10. Keypad Protocols and
Conversion, and 3.7, Adjusting System Parameters and Advanced Controls.
3L[HO
3L[HO
Press
3L[HO
to access the pixel tracking and pixel phase double slidebar. Adjust pixel
tracking first: use
sampling clock to correct image consistency and aspect ratio. For proper phase, use
21
and
2))
to increase or decrease pixel phase so that any shimmer disappears and
the image is stable throughout. See 3.6, Adjusting the Image (Size and Position
subsection) for a complete explanation of tracking and phase.
3RVLWLRQ
3RVLWLRQ
3RVLWLRQ
Press
to move the image using the double slidebar. At the slidebar, use
and
to move the image left or right, use
down. Note that
available pixel area (1024 X 768) in the projector is used for displaying the incoming
signal.
/HQV
/HQV
Press
/HQV
to display the Lens
Control menu ,where you can
access motorized control of
horizontal/vertical offsets, focus
and zoom, or turn the Intelligent
Lens System
on or off. All
™
slidebars are adjusted with
.
NOTE: Since the direction of lens travel affects the exact final position of the lens,
setting a lens position (focus, zoom or an offset) may cause the lens to reverse its
direction of travel, depending on its starting point, so that it approaches the setting
from the correct direction. Any even-numbered setting is approached from above (the
slidebar values will decrease), any odd-numbered setting is approached from below
(the slidebar values will increase).
Adjust the image clarity.
)2&86
Enlarge or shrink the image (requires a zoom lens).
=220
+25,=217$/ 2))6(7
9(57,&$/ 2))6(7
(QWHU
([LW
to select, press
and
to increase or decrease the frequency of the pixel
3RVLWLRQ
does not affect lens position, but rather what portion of the
and
Shift the lens and image left or right.
Shift the lens and image up or down.
to cancel. If you switch to a projector
3URM
3URM
and then
again without entering a
21
and
2))
to move the image up or
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
Advertisement
