Advertisement
NOTES: 1) It is recommended that the Lamp Message checkbox remain enabled. 2)
When a lamp warning message appears, press
message. The message will continued to appear upon power-up until you install a
new lamp.
Set
to the number of hours you expect to log on the current lamp before
/$03 /,0,7
replacing it. The recommended limit is 1000 hours.
NOTE: 1) If you change modes over the life of a lamp, the lamp limit you originally
expected may no longer be possible. 2) Turning the lamp on and off reduces lamp life
significantly, as do other factors.
Set which
/$03 02'(
the light output—you can choose to run the lamp as bright as
possible (i.e., using maximum power—this is the default
upon power up), or you can power the lamp with a specific
wattage from 1400-1900. Although there are exceptions, in
most lamps higher light output or higher power settings can shorten lamp life.
Use the lamp mode that best suits your brightness needs. For example, in a tiled
application you may want to precisely match brightness levels between adjacent
images—judge by eye and set each individual
you may simply always want images to be as much bright as possible—choose
.
%ULJKWQHVV
Lamp modes are described below:
N
0D[ %ULJKWQHVV
maximum power available in the projector (see Section 5, Specifications).
Keep in mind that the "maximum brightness" for any lamp gradually
diminishes with age—images will become dimmer over time.
N
Not available in this projector model.
,QWHQVLW\
N
The power supplied to the lamp will remain at a specified watt level.
3RZHU
Once you select this option, enter the number of watts representing the power
level you wish to maintain. See "
The number shown here indicates how many watts are applied to the lamp.
32:(5
Set from 1400-1900 watts as desired, keeping in mind that lower power levels
produce dimmer images. When in either "
power level remains constant. Specifying a power level of 1900 is the same as
operating in
0D[ %ULJKWQHVV
NOTES: Power level can be set only if the lamp is in "power" mode.
Not available in this projector model.
,17(16,7< ²
This read-only option lists the most lamps most
/$03 +,6725<
recently installed and recorded in the projector. Lamp History
automatically updates whenever you record a new lamp serial
number—the new lamp is added to the bottom of the list.
you want to use in order to control
The lamp will always burn as brightly as possible, driven by
" below.
3RZHU
3RZHU
mode.
to temporarily cancel the
)LJXUH
setting as necessary. Or
/DPS 3RZHU
" or
modes, the
0D[ %ULJKWQHVV
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
0D[
Advertisement
