Advertisement
This section explains how to install and set up the projector. If you are familiar with the projector and want to quickly
set it up for temporary use, follow the Quick Setup instructions below. For a more complete setup, follow the
instructions and guides covered in the remaining subsections.
NOTE: 1) The lens is not mounted when the projector is shipped from the factory. For instructions on how to install
or replace a lens, refer to 4.5, Replacing the Lens. 2) This section assumes the optional video decoder is installed.
4XLFN6HWXS
67(3
67(3
67(3
67(3
,QVWDOODWLRQ 6HWXS
Follow these steps for quick setup of the projector in a standard floor mount position.
3RVLWLRQ WKH 3URMHFWRU
Set the projector at the expected throw distance (projector-to-screen distance) and
vertical position. See 2.3, Projector Position and Mounting and Appendix E. Make
sure that the projector is level from side-to-side (see 2.7, Leveling).
&RQQHFW D 6RXUFH
Locate the main input panel at the front of the projector. The lower left area, labeled
,1387
, accepts an RGB input via BNC connectors. The upper right area (assuming
the optional video decoder is installed) accepts a composite video at
,1387
video input at
. Connect your source to the appropriate panel connectors.
&RQQHFW WKH /LQH &RUG WR $& 3RZHU
The projector has its own integral 20-amp line cord. Use this cord only. Input power
required is 200 - 240 VAC, 50 to 60 Hz @ 14 amps for 200 V. Attach a proper AC
connector, following the wiring guide on page 5-3 (note: requires qualified service
technician). Make sure the AC on/off switch (breaker) is set to ON position and that
the line voltage indicator displays an acceptable AC level when you connect to AC.
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ LV QRW
ZLWKLQ WKH VSHFLILHG YROWDJH DQG SRZHU UDQJH
7XUQ WKH 3URMHFWRU 21
Using either the built-in or remote keypad, press
second to turn the projector on (or press
about five minutes. The
input panel, should glow a steady green.
:$51,1*
3RZHU
32:(5
LED, located in the lower right corner of the front
6 H F W L R Q
,1387
3RZHU
and hold for approximately 1
21
). Let the projector warm up for
8VHU·V 0DQXDO
0LUDJH
or S-
Advertisement
