Advertisement
8VLQJWKH
.H\SDG
The infrared (IR) sensors on the front and rear of the projector
,1)5$5(' 6(16256
receive infrared signals from the IR keypad for remote control of projector functions.
For proper operation make sure that these sensors are not blocked.
Emergency access for powering down the projector in the event of a
+$5' 5(6(7
system failure. Insert a pen point or very small screwdriver.
Screw eyebolts into 4 corner holes (top or bottom) to hoist or suspend a
(<(%2/76 ²
projector. See Section 2 for details.
For safety straps when hoisting, or for brief hand transport.
6,'( +$1'/(6
67$&.,1* &251(56
three high). NOTE: All other stacking configurations require a separate hardware
accessory kit. See Section 2.
:KHQ KRLVWLQJ RU VWDFNLQJ SURMHFWRUV XVH &KULVWLH
VWDFNLQJ KDUGZDUH DYDLODEOH VHSDUDWHO\
For access/replacement of the interior lamp module. NOTE: Lamp
/$03 '225
replacement requires a qualified service technician.
Louvered grille for air intake. Remove to replace air filters.
),/7(5 6,'( *5,//(
The keypad appears in three locations:
N
Built-in to the rear of the projector
N
Infrared (IR) Remote for tetherless control up to 100 feet away
N
Wired Remote (optional) tethered to the front of the projector
While each keypad is identical in layout and provides complete control of the
projector, you may find one keypad more convenient than another for your specific
installation and application.
For secure stacking of projectors on the floor (maximum of
:$51,1*
23(5$7,21
8VHU·V 0DQXDO
0LUDJH
Advertisement
