Advertisement
67(3
7XUQ RII WKH SURMHFWRU
Turn the projector off and allow the cooling fans to stop automatically before
proceeding with Step 2.
67(3
8QSOXJ WKH SURMHFWRU
When the cooling fans have stopped, unplug the projector. Allow additional time for
the lamp to cool completely. Never handle a hot lamp, and use caution at all times.
67(3
8QODWFK RSHQ ODPS GRRU
The lamp module is secured in
place behind a lamp door
located on the left side of the
projector about half way back
(see Figure 4.2 and Figure 4.3).
N
Unlatch the center latch
by pulling up and
loosening ¼ turn.
N
Slide the 2 bottom spring
fasteners firmly towards
the center. Then pull the
fasteners towards you to lock in place. NOTE: Pull firmly—the springs are
stiff.
N
Pull the door down, then off—
the internal lamp bracket and
lamp module will be exposed.
67(3
5HPRYH ODPS EUDFNHW
Loosen both bracket knobs. Pull the bracket
straight up, lifting one end up until it is free from
its slot in the lamp cavity, and remove. See Figure
4.4.
0$,17(1$1&(
)LJXUH /DPS /RFDWLRQ
)LJXUH 2SHQ /DPS 'RRU
)LJXUH 5HPRYH ODPS
EUDFNHW
8VHU·V 0DQXDO
0LUDJH
Advertisement
