Advertisement
67(3
,QVWDOO ODPS EUDFNHW
Set the lamp bracket into the slots on the side of
the lamp compartment, making sure both ends seat
securely at the bottom of the slots. Hand tighten
the 2 knobs firmly so that the lamp is secured as
far back into the projector as possible. See right.
67(3
$OLJQ WKH ODPS
,03257$17
$/,*10(17 ,6 0$1'$725<
module is replaced or moved. Make sure the bracket is in place when aligning.
67(3
5HSODFH WKH ODPS GRRU
Insert the top edge of the lamp door
under the projector top lid. Then release
the bottom latches by pushing back and
then sliding the fasteners firmly away
from each other to lock into the
projector handle. Secure top latch. See
right.
NOTE: If the door doesn't appear to fit
properly, the lamp module is likely not
quite in all the way—push the module in
a little farther and re-align.
67(3
3RZHU XS WKH SURMHFWRU DQG UHVHW WKH ODPS WLPHU
In the Advanced menu, select the "Lamp" option. In the Lamp submenu, select the
"Change Lamp" option–enter the new serial number in the S/N text box (see Section
3, Operation if you need help entering the number). When the new number is
recorded, the lamp timer will automatically reset to "0" hours and begin to log time.
NOTES: 1) Once entered, the new lamp serial number is also automatically added to the
"Lamp History" submenu (read-only). 2) Lamp life data is required for warranty claims.
Align as per the instructions supplied with the new lamp kit.
for this projector, and must be done whenever the lamp
,03257$17
,I \RX QHJOHFW WR HQWHU D VHULDO QXPEHU WKH ODPS WLPHU
ZLOO QRW UHVHW WR ´µ DQG ZLOO WKHUHIRUH EH LQDFFXUDWH 7KH
ODPS OLIH OLPLW PD\ WKHQ H[SLUH SUHPDWXUHO\
0$,17(1$1&(
)LJXUH ,QVWDOO EUDFNHW
)LJXUH 5HSODFH ODPS GRRU
8VHU·V 0DQXDO
0LUDJH
Advertisement
