Advertisement
23(5$7,21
Shown at right is a sample channel list as
&KDQ
would be available from
. This is typically
called the channel list.
&KDQ
NOTE: The
key may display a channel list
or not, depending on what you have defined
within the Preferences menu (see Preferences
later in this section).
&KDQ
In order to use channels (
on the keypad),
you must first create them. See below.
&KDQQHO /LVW
To use a new source with the projector, a new channel must be added to projector
&UHDWLQJ D 1HZ
&KDQQHO
memory so that the projector will respond properly to an input signal from that
² $8720$7,& ²
source in the future. A new channel can be created automatically, as described here,
or it can be copied from an existing channel and then edited as necessary (see
Copying or Deleting Channels later in this section).
,QSXW
,QSXW
,QSXW
,QSXW
,QSXW
When you select a direct input (press
or
,
,
or
), the existing
channels in the projector are searched for matching input and signal parameters. If no
match to the incoming input signal is found in the currently defined channels, a new
channel is temporarily created based on factory-defined defaults for this signal. The
channel number assigned is the lowest available number from 01-99.
NOTES: 1) An automatic channel will be discarded unless one or more of its
parameters are changed, and will not appear in the channel list (see below). 2) If two
channels have the same distinguishing source characteristics except for the reversal
of sync connectors (i.e., H-sync and V-sync, are switched), they are still defined as
distinct channels. 3) You cannot define a new channel without a signal present.
If the incoming signal does match an existing channel, the image will be set up and
displayed as usual according to the parameters currently defined for that channel.
&KDQ
You can normally select a channel at any time by pressing
86,1* $ &+$11(/
(see right). If you want to
prevent a channel from
appearing in this list, you
must edit the channel as
described in Channel Edit
later in this section. Such a
channel can still be
selected by entering its
number as shown at right.
NOTES: 1) The current channel is highlighted upon entering the channel list, or, if
this channel is not displayed here, the first channel in the list is highlighted. 2)
Channels created automatically do not appear in the channel list unless a parameter
has been changed.
8VHU·V 0DQXDO
0LUDJH
Advertisement
