Advertisement
3RZHU
&RQQHFWLRQ
2SHUDWLQJ
2ULHQWDWLRQ
/HYHOLQJ
Plug the twist-locking 3-prong end of the integral line cord (30-amp, with L6-30
plug) into an appropriate grounded AC source. Twist to secure. Input voltage to the
projector must be capable of supplying between 200 and 240 VAC, 50 or 60 Hz. The
power source must be capable of supplying 2800 watts of power to the projector. See
Section 5, Specifications for complete power requirements.
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ LV QRW ZLWKLQ
WKH VSHFLILHG YROWDJH DQG SRZHU UDQJH
Caution: Once the projector is turned off, the lamp cooling fans will continue to
run for approximately five minutes to ensure that the projector and lamp have
sufficiently cooled, at which point the fans will automatically shut off. To avoid
thermal stress to the lamp, never unplug the line cord while the lamp cooling fans are
running. It is recommended that the main AC I/O switch (circuit breaker) remain in
the ON position at all times.
The projector is set up at the factory for use in a front screen, floor mount orientation.
If your initial installation is ceiling mount or rear screen, displayed images may be
upside down and/or reversed. To correct, you must change the image orientation
from within the Preferences
menu (you may prefer to do
this before physically
installing the projector in its
final position/orientation).
In the Preferences menu,
highlight and select the
"Image Orientation" pull-
down list. Select from Rear,
Inverted Rear, Front or
Inverted Front according to
your intended installation.
See Section 3, Operation for
further information.
For most installations, the lens surface of the projector is parallel to the screen—this
prevents major keystoning of the image (i.e., an image with non-parallel sides). In
addition, the projector must be kept level from side-to-side in order for the lamp to
function safely. To make small corrections to the projector's level, rotate each leg as
necessary to raise or lower.
For angled installations, see
"Special Mounting" under
2.3, Projector Position and
Mounting earlier in this
section. To adjust
keystoning through
software, see Section 3.
:$51,1*
1HYHU DOWHU WKH OLQH FRUG
)LJXUH $GMXVWLQJ WKH )HHW +HLJKW
,167$//$7,21 6(783
8VHU·V 0DQXDO
0LUDJH
Advertisement
