Advertisement
,167$//$7,21 6(783
)LJXUH ,QGHSHQGHQW .H\SDGV DQG 3URMHFWRUV
The standard IR remote keypad or the optional wired remote can be set to one of two
5HPRWH .H\SDG
3URWRFRO
different protocols — "A" or "B". To hard-wire a protocol to "A" or "B" in either
³ ,5 25 :,5(' .(<3$' ³
remote, follow Steps 1 through 5:
6WHS
Unplug the keypad from the projector (applies to wired remote only).
6WHS
Unlatch and open the empty battery compartment on the back of the keypad as shown
in Figure 2.30.
NOTE: A wired keypad opens as shown, but a cable passes through the battery
compartment cover.
)LJXUH 2SHQLQJ WKH .H\SDG
6WHS
Find the 4 jumpers located along the latching side of the battery compartment. These
jumpers set the keypad protocol and other settings so that the keypad functions in a
certain manner.
8VHU·V 0DQXDO
0LUDJH
Advertisement
