Servo Cable - Rotax 914 series Installation Manual

18.2) Servo cable

- bending radius:
Following temperatures must be measured on the positions set out in figure 51a and
must not be exceeded during take-off and after engine stop (heat accumulation).
Pos.
(1)
(2)
(3)
■ CAUTION:
Effectivity: 914 Series
Edition 2 / Rev. 0
INSTALLATION MANUAL
min. 50 mm (2")
Description
cable conduit
cable support
wire rope
All temperature limits must be verified at the first time of installation of
the ROTAX 914 into an airframe, or at any modification of the airframe
as it may influence such temperatures.
65 mm
(2,6 in.)
1
BRP-Rotax
Temperature
max. 120 °C (250 °F)
max. 120 °C (250 °F)
max. 140 °C (284 °F)
35 mm
(1,4 in.)
2
3
Fig. 68
02617
page 106
July 01/2008