Feasible Position And Location Of The Oil Tank - Rotax 914 series Installation Manual

13.6) Feasible position and location of the oil tank

See Fig. 44.
- The longitudinal axis z3 to be parallel to z-axis of the system of coordinates.
Tolerated deviation of parallelism: ± 10°
◆ NOTE:
- The oil tank (1) has to be positioned in its z-axis such that the oil level (2) is always
between 0 and -400 mm (-15.75 in.) on the z-axis.
◆ NOTE:
▲ WARNING: At higher location of the oil tank oil might trickle through clearances at
- Install the oil tank free of vibrations and not directly to the engine.
- Oil tank cover (3) and oil drain screw (4) to be easily accessible.
3
2
1
4
Effectivity: 914 Series
Edition 2 / Rev. 0
INSTALLATION MANUAL
Above notice is valid for both planes.
The profile clamp of oil tank should be between 0 mm and - 360 mm
(-14.17 in.) below the center line of the propeller shaft.
bearings into crankcase during longer periods of engine stop. If fitted
too low it might badly effect the oil circuit.
5
5
BRP-Rotax
Fig. 44
08410
page 74
July 01/2008