Oil Pressure Sensor - Rotax 914 series Installation Manual

23.3) Oil pressure sensor

See Fig. 93/94.
- location: oil pump housing
- position of connection on oil pressure pick-up (1):
- connection of
pick-up wiring: single pole screw connection for ring terminal 3 to DIN 46225
(tightening torque, max. 1Nm (8,848 in lb)
- grounding:via engine block
- graph of resistance over pressure
■ CAUTION:
BRP-Rotax offers a non-certified pressure gauge. Refer to Illustrated Parts Catalog,
latest issue.
▲ WARNING: Certification to the latest requirements such as FAR of EASA has to be
1
Fig. 93
04903
Effectivity: 914 Series
Edition 2 / Rev. 0
BRP-Rotax
INSTALLATION MANUAL
x axis
point of
mm
connectio
ca. -100
n
The graph resistance over pressure has been determined, and is
effective at the following conditions only.
ambient temperature: 20 °C (68 °F)
voltage:
tolerance:
conducted by the aircraft manufacturer.
(Ω) 200
150
100
50
0
Axes
y axis z axis
mm mm
75 ca. -150
04870
12 V
± 5%
2 4 6
Fig. 94
00229
8 10
(bar)
page 135
July 01/2008