Installing Windows 2000 Server - PRIMERGY BX620 S3 User Manual

14
Install the LAN driver advanced set up tool.
For information about onboard LAN driver advanced setup tool, refer to "5.6.1 BACS
Installation" ( pg.151). For information about LAN card advanced setup tool, refer to "5.7.1
Intel® PROSet Installation" ( pg.155).
15
Install high reliability tools.
To ensure stable server operation, refer to "Chapter 6 High Reliability Tools" ( pg.165) and
install high reliability tools.
The installation of Windows Server 2003 x64 is completed.
The installation of Windows Server 2003 has completed.
●
Before Starting Operation
After OS installation, refer to "Chapter 5 Operations after OS Installation" ( pg.125) and perform
necessary operations.

4.2.3 Installing Windows 2000 Server

1
Create driver disks.
Prepare necessary drivers before installing Windows 2000 Server.
Some drivers used with Windows 2000 Server are created from the ServerStart CD-ROM. For
how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.100).
2
Connect the USB CD-ROM drive and USB floppy disk drive to the server blade.
Use the USB Cable to connect the USB CD-ROM drive and USB floppy disk drive. For more
information on the connection procedure, refer to "Start Guide".
3
Turned on the server and configure RAID. If RAID is not required to be
configured, proceed to step 4.
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up the
BIOS Utility.
Press Ctrl C to start LSI Logic Configuration Utility
The array system is configured by using BIOS Utility. For more details, refer to "Integrated
Mirroring SAS User's Guide" in the Array Controller Document & Tool CD.
Turn off the server after configuring the array system.
4
Insert the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
PRIMERGY BX620 S3 Server Blade User's Guide
1
2
3
4
5
6
7
8
9
111