Installing Windows Server 2003 - PRIMERGY BX620 S3 User Manual

Chapter 4 Manual OS Installation
13
Install the LAN driver advanced set up tool.
For information about onboard LAN driver advanced setup tool, refer to "5.6.1 BACS
Installation" ( pg.151). For information about LAN card advanced setup tool, refer to "5.7.1
Intel® PROSet Installation" ( pg.155).
14
Install high reliability tools.
To ensure stable server operation, refer to "Chapter 6 High Reliability Tools" ( pg.165) and
install high reliability tools.
The installation of Windows Server 2003 x64 is completed.
●
Before Starting Operation
After OS installation, refer to "Chapter 5 Operations after OS Installation" ( pg.125) and perform
necessary operations.

4.2.2 Installing Windows Server 2003

■ Notes on Manual Installation
To reinstall Windows Server 2003 using the installation CD-ROM supplied with the server, start the
BIOS Setup Utility before installation, and set [Com Port Address] to [Disabled] in the [Console
Redirection] submenu of the [Advanced] menu.
"8.2.12 Console Redirection Submenu" (pg.223)
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003.
Some drivers are created from the ServerStart CD-ROM. For how to create driver disks, refer to
"4.1 Creating Driver Disks" ( pg.100).
2
Connect the USB CD-ROM drive and USB floppy disk drive to the server blade.
Use the USB Cable to connect the USB CD-ROM drive and USB floppy disk drive. For more
information on the connection procedure, refer to "Start Guide".
3
Turned on the server and configure RAID. If RAID is not required to be
configured, proceed to step 4.
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up the
BIOS Utility.
Press Ctrl C to start LSI Logic Configuration Utility
The array system is configured by using BIOS Utility. For more details, refer to "Integrated
Mirroring SAS User's Guide" in the Array Controller Document & Tool CD.
Turn off the server after configuring the array system.
108