Ganz H.264 Network Encoder Series User Manual page 89

GANZ Network camerab and encoder series Webpage User's Manual
UART Setting for serial device
UART0 : Reserved for the internal debugging purpose with RS232C.
UART1 : RS485 port
UART2 : Reserved for the communication of camera OSD control
IMPORTANT : Only UART1 is available for users but UART0 and UART2 are reserved for
internal communication purpose which are not opened to users.
NOTE : The UART setting depends on the hardware version and firmware version of your
device. The setting configuration of above is based on the hw v1.3 / firmware v1.00.06. You
can check out the version information at [Setup] – [About] – [Version] tab of the webpage.
NOTE : If you want the RS232C, please use the 485‐232 converter.
2010/2‐1 03A.00 89