Ganz H.264 Network Encoder Series User Manual page 48

GANZ Network camerab and encoder series
Step 1. Recognizing the USB wireless LAN device
1. Insert the USB wireless LAN device into the GANZ encoder and network camera.
2. After a few seconds, click the 'Refresh Network List' and you can see that the device is
listed on the window.
3. Click the device you want on the list. Then, the device information such as ESSID, mode,
MAC address, channel, and encryption are shown on the right side of the list window.
4. Click the 'Copy to user setting' button and the chosen device information is copied on
'Networks to connect' section of below.
NOTE : If 'Not connect wireless....' message is displayed after clicking the 'Refresh Network List',
please check the setting of your wireless AP/router. Also make sure the USB wireless LAN card
is mounted on the unit properly.
Step2. Connecting wireless network
If you have completed the recognition of the USB device for wireless LAN at the step1, you can
find that the 'Network name, Mode, Authentication, and Encryption' are filled automatically
according to the wireless LAN device information.
1. Type the 'Network key' and confirm it. The network key should be equal to the AP or
client PC you will communicate.
2. Set the Time out, Retry count, and Disable auto start referring to the explanation of
below.
Time out ‐ When there's no answer from the server for time out seconds, it means it
failed connecting to the server and you need to try to connect again.
Retry count – The number of retrial connections when there's no answer from the
server.
Disable auto start – When you do not want to get started the wireless network
automatically, you can check this box.
NOTE : The current time out or retry count is not renewed automatically. Try to renew the
page manually to see if the network is connected properly.
3. Set the wireless network IP configuration. If your mode is Ad‐Hoc, only static IP setting
is allowed.
Obtain IP address via DHCP ‐ Get the IP address from DHCP automatically.
Use the following IP address – Get the IP address with the manual setting. If your mode
is infrastructure (AP) networks, you should check out the range of IP address.
4. If you have completed the configuration of above, you can save or try to connect the
wireless LAN with button of Apply and Reset.
Apply – Save the current setting and apply them.
Reset – It does not save the setting of the current page and go back to the prior setting.
2010/2‐1 03A.00
Webpage User's Manual
48