Usb Wireless Lan - Ganz H.264 Network Encoder Series User Manual

GANZ Network camerab and encoder series

4.5.6. USB Wireless LAN

NOTE : This USB Wireless setting page is based on 1 channel encoder, ZN‐S1000VE. If your
camera or encoder model is other than ZN‐S1000VE, this page may not be seen according to
your model. Refer to the chapter 6. REFERENCE TO MODELS
After the wireless LAN configuration, you can use the device in one of two modes: wired or
wireless. You cannot use the camera in both modes simultaneously. To switch between wired
and wireless modes, you have to plug or unplug the Ethernet cable. Unplugging the Ethernet
cable switches the device to wireless mode automatically.
If you are ready with the USB wireless LAN device, follow the steps below.
2010/2‐1 03A.00
Successful connection
Webpage User's Manual
Available networks list is
shown by clicking the
'Refresh Network List'
button
Retrieved network device
settings values are shown
by clicking the 'Copy to
user Setting 'button
Type the network key
value of selected AP.
Connected network
status is shown by
'Update Status' button
47