GANZ Network camerab and encoder series
4.8. VCA
Refer to the separate documents, VCAsys.chm in the SDK (path : \DOC).
4.9. MOTION DETECTION
To create new
zone:
Enable the box
To delete the
existing zone:
Remove the
check in the box
The picture above is the example of zone setting on the highway image.
How to configure the motion detection zones:
1. Check the box of section A to create new zone for motion detection (It supports up to
8 zones). If you want to remove the existing zone, remove the check of the box.
2. Adjust the sensitivity and objectsize of selected zone in the section D.
3. Click apply button for each zones on the right side.
4. If you have completed the configuration of zones with the step 1~3, check the Motion
Enable box to enable the motion detection and click the apply button E.
5. Now, get out of the [Setup] page and go to the [View] page to see the activation of the
zone configuration. When any motion is detected in the configured zone, the zone will
flicker every time.
2010/2‐1 03A.00
A
B
Sensitivity and
ObjectSize user
configured are
shown
D
C
You can adjust
The location of
the sensitivity
the zone is
and objectsize
shown with
of each zone.
normalized
figures.
Webpage User's Manual
E
72