Ganz H.264 Network Encoder Series User Manual page 49

GANZ Network camerab and encoder series
5. Disconnect the Ethernet cable from the device. Unplugging the Ethernet cable switch
the device to wireless mode automatically.
6. Wait about 30~40 seconds to switch the wireless mode.
NOTE : Switching time between wired and wireless modes may take longer than expected
according to the network connections.
NOTE : When rebooting the device with wireless mode, device's boot time may be increased
to 4~5 minutes.
NOTE : If the wireless LAN is not connected successfully, make sure the USB wireless LAN card
is mounted on the unit properly. Click 'Refresh Network List' button and try to search network
devices again. Please check out the step1 and step2 again.
2010/2‐1 03A.00
Webpage User's Manual
49