Setting Ntp Server - Ganz H.264 Network Encoder Series User Manual

GANZ Network camerab and encoder series

4.5.3. Setting NTP server

NTP Server Lists
You can set up to 4 NTP servers as you can see at the example of above. To enable the NTP
servers, DNS server setting should be done in advance in the menu of TCP/IP page and please
check out if the DNS configuration is accurate.
I am SNTP Server
it's also called 'Squid server.' When you have multiple NVC servers, it helps to reduce the
network load because only the one with 'I am SNTP Server' checked will get the time
information from the NTP servers and other NVC servers are synchronized with this Squid
server.
How to use:
1. Enable 'I am SNTP server' of squid server and click Apply.
2. Access the webpage of the GANZ ENCODER AND NETWORK CAMERA which is
supposed to be the client device of the squid server. Go to [System Options – NTP] and
type the IP address of squid server on the 'NTP Server 1s't. (Format example :
192.168.11.4)
3. Click 'Test' button to find out if it works fine.
NOTE: It will take about 3~4 minutes until the squid server response.
4. Go to [Setup – Basic Configuration – Date & Time] and choose the 'Synchronize with
NTP server' for the method of New Server Time menu. Make sure if the 'NTP Server'
displays the designated squid server's IP correctly with red characters.
5. Click 'Apply' button and it will be restarted.
2010/2‐1 03A.00
Webpage User's Manual
42