GANZ Network camerab and encoder series
4. SETUP CONFIGURATION
In Setup page you can configure the setting values of GANZ encoder series, click Setup on the
main page and you can see the menu tab on the left side of the Setup as below. A Viewer is
not allowed to enter the setup page. You will need the Operator or Administrator account for
this.
4.1. LOG IN
To access the Set up configuration do the following:
1. Enter "root" and "pass" (case sensitive) in the User ID and Password (root is the
default setting for these fields)
2. Click OK
Apply and Reset
At the bottom of the every page of Setup, you can see two buttons, Apply and Reset.
Apply – Send the request to NVC server and get the expected result.
Reset – Remove the typed values or settings of current page and go back to the original setting
values.
2010/2‐1 03A.00
Webpage User's Manual
15