GANZ Network camerab and encoder series
4.5.5. USB/SD Storage
NOTE : This USB/SD setting page is based on 1 channel encoder, ZN‐S1000VE. If your camera
or encoder model is other than ZN‐S1000VE, this page may not be seen according to your
model. Refer to the chapter 6. REFERENCE TO MODEL.
This page is provided to search mounted USB/SD storages device and select one of them for
data recording. Please follow the steps described at the below. After setting this page, move
to the menu of [System Options ‐ AVI File Recorder] page and start the recording.
How to set the recording device
1. Insert a USB or SD memory card.
2. Click the 'Refresh USB/SD Device List' and you can find that the devices are listed on
the window. If the storage device is not listed right after mounting, wait for a few
seconds and click the Refresh button again as it might take some time until the device
is recognized.
3. Select and the device on the list and then the device information such as name, type,
total capacity, free space and status are shown on the right side of the list.
4. Click the 'Select Record Device' button and the chosen device information is listed on
the Record Device Control.
5. Click Apply button to use the selected device for recording.
6. If you have completed the steps above, go to the [System Options – AVI File Recorder]
menu and you can start the recording.
NOTE : If the total capacity and free space are not shown, refresh the device list in a few
seconds. Because it takes some time to bring the file system information to the web page.
If the space information is not shown still, your storage device is not formatted properly.
Format your storage device and try to refresh again.
Formatting the disk
2010/2‐1 03A.00
Webpage User's Manual
Mounted devices are shown by
clicking 'Refresh' button
Storage device Information is
displayed by clicking the
'Select Record Device' button
Click Apply button to use
selected device.
Detail device
information by
selecting one of
items on the storage
list
45