Limited Functions Under Safety Mode - Ganz H.264 Network Encoder Series User Manual

GANZ Network camerab and encoder series
If you see the screen below, that means your system has rebooted at 'Safety Mode' and you
should follow the steps.
Click the 'Reboot' button on the webpage
1. Wait for about 1 minute until the system gets restarted at normal condition.
2. Try to access the webpage again and check out if it displays the webpage in normal.
If your system still keeps rebooting at Safety Mode even with the steps of above?
It means some parts of your firmware files on the system are damaged and not available any
more. Please try the steps of below to recover the firmware file.
1. Run the ZNS‐GIT IPAdimn Tool.exe program in the SDK (\BIN\TOOLS\AdminTooL).
Then, you may find that your GANZ encoder and network camera is with 'Safety
Mode' on the ZNS‐GIT IPAdimn Tool as below.
2. Right‐click at the device name and select the 'Update' menu.
NOTE : Please find the detailed instruction to update firmware, which is located at SDK (\DOC).
The section '2.6. How to update firmware remotely by ZNS‐GIT IPAdimn Tool' will guide you to
understand the updating procedure.
If you have completed the firmware update, you can access the webpage and check out if your
system boots in a normal booting mode.

5.4. Limited functions under Safety Mode

Though it varies by operating system, typically safe mode loads as few executable modules as
possible and usually disables normal working of device.
Available functions
IP change by ZNS‐GIT IPAdimn Tool
Scanning by ZNS‐GIT IPAdimn Tool
Searched by UPnP program
Limited functions
RTSP or HTTP streaming
Event messages or alarming
Recognition of HTTP API commands
2010/2‐1 03A.00
Webpage User's Manual
76