GANZ Network camerab and encoder series
1. INTRODUCTION
1.1. Welcome
This manual explains how to interface with the GANZ ENCODER AND NETWORK CAMERA series
using a standard Web browser (for example Microsoft Internet Explorer).The Web Page of the
GANZ ENCODER AND NETWORK CAMERA is implemented with protocols below.
•
HTTP API – Parameter configuration commands
•
RTP/RTSP – Video, Audio, and Metadata Streaming
•
Active X program – Image display on client PC
NOTE:
This manual is generated based on ZN‐S1000VE, 1ch network video encoder. For all of GANZ
encoder and network camera, most of the user interfaces of web page can be applied equally.
But, inevitably some parts have been designed otherwise than ZN‐S1000VE according to the
characteristics of each model. For this reason, you should also refer to the section 6.
REFERENCE TO MODELS if you're using multi channel solution or network camera type.
1.2. Getting Started
You will need to install your GANZ ENCODER AND NETWORK CAMERA series before using this
manual. Refer to the GANZ ENCODER Hardware Manual supplied with the SDK. Once installed,
apply power to the system and refer to the 'Installation Guide' or 'Hardware manual' for each
model for more detail installation guide.
1.3. IP address setting
How to find the IP Address of your device:
You can figure out the default IP address of your product from MAC address. If you have
succeeded in converting the IP address like the picture below, just type the address on the
address bar of the Internet Explorer.
2010/2‐1 03A.00
Webpage User's Manual
6