Io Configuration; Di/Do Control - Ganz H.264 Network Encoder Series User Manual

GANZ Network camerab and encoder series Webpage User's Manual

4.6. IO CONFIGURATION

4.6.1. DI/DO control

NOTE : This DI/DO setting page is based on 1 channel encoder, ZN‐S1000VE. If your camera
or encoder model is other than ZN‐S1000VE, move to the chapter '6.REFERENCE TO MODEL'
and you can refer to the different part only from this page.
If you should install the additional device such as alarm system or sensor system, you can
configure the DI (Digital Input) and DO(Digital Out) in this page.
DI Resource Type
You can choose the DI resource type, RELAY or VOLTAGE (The maximum is 5V).
DI & DO Status
It reflects the current states of actual DI and DO. In case of ZN‐S1000VE, 2 of DI and DO are
supported for each. Refer to your GANZ ENCODER AND NETWORK CAMERA model
specification for supported number of DI and DO.
Scenario Example
When it's assumed that DI#1 and DO#1 are coupled by event system. The DI#1 trigger type is
Normal Open. Suddenly DI#1 is triggered by any kind of event.
2010/2‐1 03A.00 64