Io_Outp_Ctrl 1-4 - AVT Pike Technical Manual

Camera interfaces
Register Name
0xF1000320 IO_OUTP_CTRL1
0xF1000324 IO_OUTP_CTRL2
0xF1000328 IO_OUTP_CTRL3
0xF100032C IO_OUTP_CTRL4

IO_OUTP_CTRL 1-4

The outputs (Output mode, Polarity) are controlled via 4 advanced feature
registers (see Table 28: Advanced register: Output control
The Polarity field determines whether the output is inverted or not. The out-
put mode can be viewed in the table below. The current status of the output
can be queried and set via the PinState.
It is possible to read back the status of an output pin regardless of the output
mode. This allows for example the host computer to determine if the camera
is busy by simply polling the BUSY output.
Note Outputs in Direct Mode:
For correct functionality the Polarity should always be set
to 0 (SmartView: Trig/IO tab, Invert=No).
Field
Presence_Inq
---
Polarity
---
Output mode
---
PinState
Same as
IO_OUTP_CTRL1
Same as
IO_OUTP_CTRL1
Same as
IO_OUTP_CTRL1
Table 28: Advanced register: Output control
on page 87).
Bit Description
[0] Indicates presence of this
feature (read only)
[1..6] Reserved
[7] 0: Signal not inverted
1: Signal inverted
[8..10] Reserved
[11..15] Mode
see Table 29: Output routing
on page 88
[16..30] Reserved
[31] RD: Current state of pin
WR: New state of pin
PIKE Technical Manual V4.1.0
87