Outputs - AVT Pike Technical Manual

Camera interfaces
Signal
IntEna (Integration Enable) signal
Fval (Frame valid) signal
Busy signal
IntEna
FVal
Busy
Operation state
read
Note
• Switching trigger delay to ON also switches external
Trigger_Mode_0 to ON.
• This feature works with external Trigger_Mode_0 only.

Outputs

Note For a general description of the outputs and warnings see
the Hardware Installation Guide, Chapter PIKE output
description.
Output features are configured by software. Any signal can be placed on any
output.
The main features of output signals are described below:
Table 27: Output signals
Output
mode
selectable
via software
Figure 43: Output block diagram
Description
This signal displays the time in which exposure
was made. By using a register this output can be
delayed by up to 1.05 seconds.
This feature signals readout from the sensor. This
signal Fval follows IntEna.
This indicator appears when the exposure is being
made; the sensor is being read from or data trans-
mission is active. The camera is busy.
Polarity
selectable
via software
Operation state
read
Opto-
Coupler
Output signal
PIKE Technical Manual V4.1.0
86