Table of Contents
Advertisement
Description of the data path
Quick parameter change timing modes
Shutter Update Command
Current Charge Time
Sync
FVal
Note
Configuration
To configure this feature in an advanced register: See
152: Advanced register: Format_7 mode mapping
297.
Why new timing modes?
Former timing of the PIKE cameras showed the same behavior as MARLIN
cameras:
•
Frame rate or transfer rate is always constant (precondition:
shutter < transfer time)
•
The delay from shutter update until the change takes place: up to 3
frames.
Figure 80: Former standard timing
this behavior. It shows that the camera receives a shutter update com-
mand while the sensor is currently integrating (Sync is low) with shutter
setting 400. The camera continues to integrate and this image is output
with the next FVal. The shutter change command becomes effective with
the next falling edge of sync and finally the image taken with shutter
200 is output with a considerable delay.
•
Parameters that are sent to the camera faster than the max. frame rate
per second are stored in a FIFO and are activated in consecutive images.
400
Figure 80: Former standard timing
Principally a PIKE camera is not able to recognize how many parameter the
user will change. Due to the fact that communication between host and cam-
era is asynchronous, it may happen that one part of parameter changes is
done in image n+1 and the other part is done in image n+2.
To optimize the transfer of parameter changes there is a new timing mode
called Quick Format Change Mode, which effectively resets the current shut-
ter.
Therefore you can choose between the following update timing modes:
on page 135 demonstrates
200
continues integrating
with shutter eg 400
outputs image
with shutter 400
PIKE Technical Manual V4.1.0
Table
on page
integrates image
with
shutter 200
outputs image
with shutter 200
135
Advertisement
Table of Contents
