Chapter 7. SLT Features
Considerations
•
The second extension called using the Reset Call feature must have the same number of digits as
the first extension.
Room Monitoring
Version 3.5 and higher
Description
This feature allows the user to monitor the sounds in a room from another extension or room. The
transmitter in the telephone handset is used as a remote "microphone" for monitoring these sounds.
To activate this feature, the monitored extension must enable the Room Monitor feature before the
monitoring extension can listen to the sounds in the room. The monitored extension can be enabled
using an SLT, DSLT, or Key Telephone. No special programming is required to allow an extension to
enable the monitored mode.
Operation
To set up the monitored extension:
1. Dial the monitored extension access code (default 775)
Note: The handset must be off-hook to activate the
Room Monitor feature.
When a monitored extension receives a call, the caller hears a busy tone. Additional operations may
be performed from the monitored extension when it is in monitored mode:
1. Placing the handset back on-hook
2. Pressing digits 0-9, *, #
3. Flash
It is not possible to monitor an extension from an SLT telephone.
Hardware Requirements
•
N/A
Related Programming
•
FF1-0-03: Extension COS (Allow/deny Busy Override Send—Monitoring extension)
•
FF1-2-02: Dial Plan at DT Pattern 1
•
FF1-2-03: Dial Plan at DT Pattern 2
7-34
Action
Action
DBS 576HD (USA) issued September 2001
Section 700 - Operation
Result
You will hear a confirmation tone after
the monitored extension has enabled the
Room Monitor feature.
Result
Monitored mode is cancelled. Extension
returns to idle.
No response is given. Extension remains
in monitored mode.
Monitored mode is cancelled. Dial tone is
returned to handset.
576-50-700