System Speed Dial - Panasonic DBS 576 HD Technical Manual

Section 700 - Operation
• Storing a new number erases any previously stored data.
• If the called party's number and name are stored in the PSD code, that information appears on the
display when you use the speed dial code.
• Speed dial numbers can contain up to 24 characters. The following table reflects which keys to
use.
To indicate. . .
Digit or character
Intercom Level *
MCO Code **
Pause
DP - DTMF Code
SSD Code
Hyphen (-)
Display Number (Start / Stop) ***
DTMF Conversion After the
Other Party Answers
* Indicates that the digits that follow are either a feature access code or an extension
number. (Not needed if your System is set for Intercom Level.) See Note below.
** Indicates that the digits that follow are for an outside number and the System should
seize the next available trunk when dialing. (Not needed if your System is set for CO
Level.) See Note below.
*** Indicates that the enclosed digits should not be displayed during dialing. Must precede
and follow the digits that you do not want displayed. Example: AUTO *2 555-4143
AUTO *2.
Note: The System has two levels - CO Level and Intercom Level. If set at CO Level (default),
you must enter the code for Intercom Level when programming a feature access code or
extension number for speed dialing. If the System is set at Intercom Level, you must enter the
MCO Code when programming an outside number for speed dialing.

System Speed Dial

You can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can be
programmed, depending on how the System is configured. In an 80 SSD-number system, the SSD
numbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins
000-799.
Operation
To assign SSD numbers:
1. Lift the handset or press the ON/OFF key.
576-50-700
Enter/Press
0, 1 - 9, *, #
AUTO * #
AUTO * 0
REDIAL
AUTO * *
AUTO
NN(N)
PROG
AUTO * 2
AUTO * 3
Action
DBS 576HD (USA) issued September 2001
Chapter 7. SLT Features
Shown on Display?
yes (unless preceded by AUTO * 2 - see ***
below)
no
no
no
no
no
yes
Result
Intercom dial tone
5-79