Direct Line Appearances - Panasonic DBS 576 HD Technical Manual

Chapter 7. SLT Features
Operation
To assign a DSS/BLF key
1. Press the PROG key.
2. Press the FF key to be assigned the DSS/BLF appearance.
3. Press the Redial key.
4. Enter the code for the desired DSS/BLF mode as follows:
9+ Ext # ---- DSS Mode Only
81+ Ext # --- DSS/BLF Immediate Ring
82 + Ext # -- DSS/BLF Delayed Ring
83 + Ext # -- DSS/BLF No Ring
5. Press the HOLD key.
To make an intercom call using the DSS/BLF key:
1. Press the flashing DSS/BLF key.
To pick up a call on a DSS/BLF key:
1. Go off-hook or press the flashing DSS/BLF key.
Hardware Requirements
• N/A
Related Programming
• FF1-0-02: BLF Call Pickup
• FF4-0-04: FF Key Assignment
Considerations
• If several calls arrive at a DSS/BLF key, the calls are queued and ring on a first-in, first-out basis.
• If a BLF key has a second call while busy and off- hook signaling is enabled, the BLF key starts
blinking. The call can be answered by pressing the BLF key or going on hook and then off hook.

Direct Line Appearances

Direct Line (DL) keys are used to originate and receive calls over specific trunk numbers (DL keys
can be assigned to any trunk number).
The LED for a DL key will flash red on an incoming call even if the CO line is set to ring. If another
extension answers the call, the LED on the telephone will light solid red.
5-58
:
Action
Action
Action
DBS 576HD (USA) issued September 2001
Section 700 - Operation
Result
Result
Result
576-50-700