Figure 4.12 Colour Code For Connection To The Expansion Cabinet(S); Hardware And Software Configuration - Aastra AXD Installation And Maintenance Manual

4.5.3

Hardware and software configuration

This card does not require any hardware or software configuration.
4.5.4 Installation and wiring
The RUCV-D card can be hot-plugged/removed in an operational AXD iPBX.
Warning:
Conncting an RUCV-D card to a UCV-D card requires a specific cable supplied with the
expansion cabinet (see cabinet reference in Section 7.2.7.7 ).
For a duplex configuration comprising one or two expansion cabinets, a second RUCV-D
card must be added to each expansion cabinet. A cable for connecting a main cabinet is
provided with each RUCV-D card (see RUCV-D reference in Tableau 7.1 ).
A colour code is indicated at the back of the AXD cabinets to facilitate connection to the
expansion cabinet(s). The XD column shows the connection of cables to the main
cabinet. The 2XD and 3XD columns show the connection of cables to the expansion
cabinets. You only need to follow this code to carry out the wiring operation.
Read this column
for connecting
cables to the
main cabinet
DB25-F connector
Figure 4.12 C
Colour clamps are provided with the cables. Install the clamps on the connection cables,
respecting the colour code.
Installation and Maintenance Manual - Aastra 5000
Description des sous-ensembles
After a switchover the duration of which depends on the configuration
(15 s. to 1 min.), the passive CPU card takes over and becomes active in
the following three cases:
• If the active card is removed
• If the active card remains idle for 2 minutes
• If a hardware failure is detected on the active UCV-D card (in this
case, a hardware fault detection is performed. The unavailability time
on the cabinet can, therefore, be up to 3 minutes).
XD
B-2XD
B-3XD
A-2XD
A-3XD
OLOUR CODE FOR CONNECTION TO THE EXPANSION CABINET
01/2011
Read this column for wiring
A2XD EXPANSION CABINET
on the
Read this column
for connecting
cables to the
2XD 3XD
A3XD EXPANSION CABINET
B
B
A A
AMT/PTD/PBX/0058/4/6/EN
( )
S
Page 159