Indicators - Aastra AXD Installation And Maintenance Manual

4.3.2.1

Indicators

The UCV-D card has 8 indicators plus the ones integrated in the LAN connection. An
indicator may contain several LEDs
:
INDICATOR
EIP No.1 ON green
EIP No. 2 ON green
SHTD (red) Red flashing
Linux shutdown
ON green
Off
DISK ON green
RUN (green) On steady
Off
Flashing
DPLX (green) Green flashing
ON green or OFF
LAN - 1 yellow LED:
2 LEDs integrated Off
in the RJ45 On
connector Flashing
- 1 green/yellow LED:
Off
ON green
ON yellow
ACT ON green
Off
OP ON green
ON red
Note: The "OP" and "ACT" indicators are useful in a duplex configuration. In a simplex
configuration, these indicators are always on (green) when the card is
operational.
Installation and Maintenance Manual - Aastra 5000
Description des sous-ensembles
STATE
Activity on Ethernet link: EIP daughter card No.1
Activity on Ethernet link: EIP daughter card No.2
PBX shutting down after the SHTD button has been pressed, or
following a Reset OS or Reboot OS request by MMC (do not power
off the device).
Power off authorisation
Normal operation.
Disk is being used
ON upon card reset and during OS restart.
OFF during application start.
Flashing when the application is operational.
Clock received from UCV-D
No clock (UCV stopped or cable disconnected)
Half Duplex link.
Full Duplex link.
Collisions
Link not set up.
Link set up at 100 Mb/s.
Link set up at 10 Mb/s.
Card active
Card not active
Board operational
Card out of service
TABLEAU 4.6 OVERVIEW OF THE UCV-D CARD INDICATORS
01/2011
EXPLANATION
AMT/PTD/PBX/0058/4/6/EN
Page 145