Indicators - Aastra AXD Installation And Maintenance Manual

4.6.2.2

Indicators

The UCV-L card includes 2 sets of 5 superimposed indicators; each indicator may have
2 LEDs:
INDICATOR
EIP No.1 ON green
Lnk/Speed Off ON yellow
EIP No. 2 ON green
ON yellow
DISK ON green
SHTD Red flashing
Linux shutdown ON green
Off
RUN (green) On steady
Flashing
AUX (green) On
BVF Green flashing
(green/orange) ON green or OFF
ON orange
S.EXT ON green
(green/red)
ON red
Off
S.DECT ON green
(green/red) ON red
Flashing green (slowly)
Flashing
(average)
Flashing
(rapidly)
MST DECT On
(green) Off
LAN - 1 yellow LED:
2 LEDs integrated Off
in the connector On
Flashing
- 1 green/yellow LED:
Off
ON green
ON yellow
AMT/PTD/PBX/0058/4/6/EN
Page 172 01/2011
STATE
100 MHz, activity on Ethernet link: EIP daughter card No.1
10 MHz, activity on Ethernet link: EIP daughter card No.1
100 MHz, activity on Ethernet link: EIP daughter card No.2
10 MHz, activity on Ethernet link: EIP daughter card No.2
Disk is being used
PBX shutting down
Power off authorisation
Normal operation
Operating problem
Card in operation
not used
Run (Voice mail operating)
Voice mail not working (BVF not activated or faulty)
BVF initialising
Correct synchronisation clock (primary network or DECT port)
Synchronisation clock fault alarm
No correct synchronisation clock (primary network or DECT port)
DECT synchronisation correct
DECT synchronisation loss alarm
Received synchronisation not validated
green Synchronisation test
Synchronisation successful
green
Active synchronisation master iPBX
Slave or Master iPBX
Half Duplex link.
Full Duplex link.
Collisions
Link not set up.
Link set up at 100 Mb/s.
Link set up at 10 Mb/s.
TABLEAU 4.17 PRESENTATION OF UCV-L CARD INDICATORS
Description des sous-ensembles
EXPLANATION
Installation and Maintenance Manual - Aastra 5000