Aastra AXD Installation And Maintenance Manual page 449

Table 23:
OPERATION
• Check that the expansion
ribbon cable has been
fitted (AXS/AXS12/
AXS6).
• Install the expansion
cards.
• Install the cables exactly
like in the old cabinet.
• Fit the new cabinet.
• Connect the mains cable
(once the cabinet
closed if it is an AXS/
AXS12/AXS6 iPBX).
• Power on the iPBX.
Installation and Maintenance Manual - Aastra 5000
Maintenance
DETAILS OF THE OPERATION / COMMENTS
This operation concerns only the AXS/AXS12/AXS6 iPBX.
• Check that the expansion ribbon cable connecting the CPU card
to the expansion cable connector is connected.
Install the expansion cards from the old cabinet in the new cabinet.
AXL and AXS/AXS12/AXS6 iPBXs
• Slide the card along the card guides until it clicks into place.
• Lock the card in place using the 1/4 turn locks (see Figure 4.1 ).
• At the back of the RUCV card
• On the front panel of the expansion cards
• connect the expansion cabinet to the main cabinet using the
connection cable.
• Do not forget to wire the protective ground.
In the case of an AXS/AXS12/AXS62 cabinet,
Attention :
do not connect the mains cable. The cabinet
must first be closed.
• Connect one end of the mains cable to the power supply module
is of the expansion cabinet (AXL) or directly to the AXS/AXS12/
AXS6 cabinet and the other end to a grounded mains power
point.
The iPBX must be powered off when installing
Attention :
the mains cable.
Never connect network lines while the mains
power cable is unplugged.
• Before powering on the cabinet, check that the following tasks
have been performed:
- all line connections are installed,
- all equipment has been connected to a grounded power point.
• Power on the iPBX:
- power on the expansion cabinet then the main cabinet.
- "I/O" switch on the power supply module set to "I".
• Check the status of the indicators (see Sections 4.6 to check that
the functional statuses provided by the indicators are correct).
01/2011
AMT/PTD/PBX/0058/4/6/EN
Page 449