Hardware Configuration - Aastra AXD Installation And Maintenance Manual

Indicators
The six LEDs described in the table below show the operating state of the card:
INDICATOR
COL (green)
LINK (green)
TX (green)
RX (green)
RUN (green)
NRA (red)
This VoIP card has no signalling indicator.
The front panel of the PT2 card includes:
• an "RST" push-button used to reset the card (manufacturer reserved),
• an "NMI" push-button used for an non maskable interruption of the processor
(manufacturer reserved).

4.13.5.4 Hardware configuration

The PT2 card has a CA1 configuration microswitch.
Operating mode:
• normal mode
• programming mode (programming the flash memory using the
programming tool card)
(1) Factory delivery configuration in bold characters
Installation and Maintenance Manual - Aastra 5000
Description des sous-ensembles
STATE
On
On
On
On
Flashing slowly
Flashing rapidly
On
TABLEAU 4.53 PRESENTATION OF THE PT2 CARD INDICATORS
DESIGNATION
TABLEAU 4.54 HARDWARE CONFIGURATION OF THE PT2 CARD
Ethernet collision
Status of the Ethernet link:
Good link with the Ethernet switch
LAN transmitting
LAN receiving
Card downloading status:
Loading software
Card in operation
Internal failure detected
AMT/PTD/PBX/0058/4/6/EN
01/2011
EXPLANATION
CONFIGURATION (1)
CA1 on OFF
CA1 on ON
Page 241