4.13.7.2 Physical description (see Figure 4.49 )
Connectors
The connector J2 is reserved for factory tests.
This card has no external connections.
Indicators The indicators are located on the card circuit and not on the front panel.
NAME
CR1 (red)
CR2 (red)
4.13.7.3 Hardware configuration
Jumper SW1 must be configured as shown on the diagram, with slots 1 and 2 connected
together.
4.13.7.4 Installation and wiring
This card has no external connections.
Installation and Maintenance Manual - Aastra 5000
Description des sous-ensembles
STATE
On steady
Flashing rapidly
TABLEAU 4.67 PRESENTATION OF THE CP1 CARD INDICATORS
Incorrect operation
Card in service
AMT/PTD/PBX/0058/4/6/EN
01/2011
EXPLANATION
Page 255