Restarting And Validating The New Version - Aastra AXD Installation And Maintenance Manual

6.8.3

Restarting and validating the new version

After restarting in R5.2, it is necessary to refresh the browser screen to access
Rappel :
AMP. It is advisable to close and restart it. Moreover, it could be necessary to
erase the cookies and the temporary files of the navigator to obtain a correct
display in the Web browser.
After the software is upgraded, the installed version is not automatically validated during
switchover. You must validate the new version manually after noticing that it is running
satisfactorily.
You can validate it through the menu "SYSTEM > Restart request".
IMPORTANT NOTES:
As long as the new version is not validated:
• it remains "in test",
• a red frame is displayed in the menu area indicating that the active version is not valid.
• It is possible to restore the previous version (see SYSTEM> Restart request) but the
data modified while the software had not been validated will be lost.
Attention :
• It is not possible to back up data until the software is validated.
It is advisable to validate the new version as quickly as possible (once
you observe a normal operation).
Procedure
Validation and possible cancel requests are proposed in the menu "SYSTEM/Restart
request" as indicated below.
• To validate the release "in test", click "Validate the version". The system restarts
Installation and Maintenance Manual - Aastra 5000
Installation and activation
The restore operation will not be possible on the recovered version.
AMT/PTD/PBX/0058/4/6/EN
01/2011 Page 379