Adding An Expansion Cabinet - Aastra AXD Installation And Maintenance Manual

6.3.7

Adding an expansion cabinet

The iPBX can be fitted with one or more expansion cards to increase the system capacity.
Avertissement :
6.3.7.1 Adding an expansion cabinet (AXD)
Procedure
• Back up the customer configuration.
• Power off the iPBX.
• Install the expansion cabinet cards.
• Install the expansion cabinet and connect it to earth (see Sections 3 and 6.2.5).
• Connect the expansion cabinet to the main cabinet using the connection cable(s),
according to the simplex or duplex configuration of the cabinets and colour codes (see
Sections 4.5.4.1).
• Install the cable on the front panel of the expansion cabinet cards.
• Install the battery cabinet if available.
• Connect the two battery leads.
• Make sure the polarity is correct.
• Connect the battery to the "48V BATT." connector located at the back of the AXD
cabinet.
• Connect one end of the mains cable to the power supply module(s) of the expansion
cabinet and the other end to a grounded mains power point.
• Power on the iPBX (expansion cabinets first then the main cabinet).
• Check that the yellow and green indicators on the front panel of the cabinet sub-
assemblies are lit, and that no red indicator is on (refer to Sections 4.3 to 4.14 to check
that the operating conditions shown by the indicators are correct).
• From the AMP, check that the software has detected the cabinet expansion.
• Configure the new expansion cabinet equipment
• Save the configuration.
AMT/PTD/PBX/0058/4/6/EN
Page 362 01/2011
The configuration data needs to be changed if the system is expanded.
Before adding new components, first back up the data.
Installation and activation
(see AMP operating manual).
Installation and Maintenance Manual - Aastra 5000