Hardware Configuration - Aastra AXD Installation And Maintenance Manual

components above the PCB is limited to 77 mm.
The ADS 150X card is secured on cross-pieces screwed on the back of the cabinet.
An "I/O" switch on the front panel of the AXS cabinet is used to power the supply on and
off.
The fuse holder is located between the "I/O" switch and the mains socket at the back of
the cabinet.
ADS 150X is fitted with an 80 mm diameter fan, located on the left of the power supply
module.
Connectors
The back plane of AXS and XS12 cabinets comprises:
• A mains socket
• a 4-pin battery connector.
Indicators
An "ALIM" indicator located on the front panel of the UCV card indicates when on:
- mains presence, and,
- rectifier operation.
Note: This LED also indicates a mains failure (flashes slowly) and abnormal operation
(flashes rapidly or LED out) of the power supply (both power supplies if there is
an expansion cabinet).
4.2.5.5

Hardware configuration

There is no hardware configuration. ADS 150X accepts 115 V and 230 V.
4.2.5.6 Installation and wiring
The ADS 150X power supply module comes with a connection cable fitted with a 4 pin
connector, with a centring piece to prevent polarity inversion when connecting the backup
battery.
Installation and Maintenance Manual - Aastra 5000
Description des sous-ensembles
AMT/PTD/PBX/0058/4/6/EN
01/2011 Page 139